Deutz 1012 Specifiche Scaricare il pdf (Pagina 218)

Service Training

Section 4.7

Page 6

SEALING THE TILT CYLINDER

SEALING THE PISTON ROD

Condition: Cylinder removed

- Clamp the cylinder with the eyebolt of the cylinder barrel (8) in a vise.

- Unscrew the hexagonal nut (17) while holding the piston rod with a 41 mm flat spanner and remove the

eyebolt (18) from the piston rod (9).

- Open the flanged retainer for the cylinder head (13).

- Screw the cylinder head (13) out of the barrel (8) with a suitable hook spanner.

- Inspect the piston rod for damage.

- Remove the cylinder head seals and clean the cylinder head.

- Install new cylinder head seals.

- Grease the seals slightly, slide the cylinder head on the piston rod, screw into the barrel and tighten to

300 - 350 Nm, drive in the flanged retainer.

- Screw the eyebolt (18) with nut (17) back into the piston rod.

- Re-assemble the cylinder and adjust the eyebolt (18) according to the adjustment procedures and lock

it with the nut.

1 Bearing

2 Setscrew

3 Piston

4 Guide ring

5 Piston seal

6 Rod seal

7 Bushing - piston stroke limiter

8 Cylinder barrel

9 Piston rod

10 Guide ring

11 Sealing ring

12 Support ring

13 Cylinder head

14 Rod seal

15 O-ring

16 Wiper

17 Hexagonal nut

18 Eyebolt

1 2 ... 213 214 215 216 217 218 219 220 221 222 223 ... 281 282

Deutz 1012 Specifiche Pagina 218